Rain Rebound

5 Ways To Help Your Infield Skin Rebound From Rain Quickly

(following excerpts are from original material at Ballfields.com)

While the western quarter of the US is battling a daunting drought, the central portion of the US has been dealing with lots of rain over the past couple of months. Think about it. In a three week span, the entire state of Texas went from a major 4-year drought to being totally drought free. It takes a lot of rain to knock out four years of drought in just three weeks. With all that rain, surely there are many who are having issues with trying to get their fields ready after a rain. Let’s take a look at what you can do to help your fields recoup from a rain event as quickly as possible.

  1. Keep Your Infield Properly Graded
    First and foremost, make sure that your infield is properly graded to promote positive surface drainage. Ideally, the infield should be graded so that the area around the base of the pitcher’s mound is the highest point on the infield with the surface grade then sloping away from the mound in all directions. However, depending on the lay of the land that the field was built on, the other way of grading an infield would be to “sheet drain” it. This means the entire infield is tilted in one direction; for example, the infield may tilt from the first base foul line towards left field. In either instance, both of these surface grades are only efficient at draining the water off it if the surface is smooth and consistent. In other words, there are no high spots or low spots to impede or deflect the drainage. Proper nail and float dragging are crucial maintenance practices that, when done correctly, will keep your skin surface in smooth and consistent surface draining condition.
  2. Maintain Your Turf Edges
    Maintaining your turf edges to prevent lip buildup will allow the water to easily pass over from infield skin to turf area without any issues. When infield soil and infield topdressing buildup in the edges of the grass, that ridge or “lip” impedes the water from freely moving off the field. The more severe the lip, the more water it will hold back onto the infield skin. Properly maintain those lips to keep them from slowing your field from recuperating.

  3. Choose Appropriate Infield Soil Material
    The right infield soil material has a huge impact on speed of reentry onto an infield after a rain. Infield soils that are either high in silt or high in fine and very fine sand drastically effect how quickly the field is playable again after a rain. Even worse is when you have both problems! High silt and high fine sand content infield soils can take a day or multiple days to recuperate. Have your infield soil tested to check to see how your soil material lines up with the acceptable specifications. Strive for a balanced infield soil with the right amounts of medium to coarse sand and the proper ratio of silt to clay. It’ll make all the difference in the world as to how easy it will be getting the infield back into playing condition.
  4. Use an Infield Top Dressing
    Use a topdressing on your infield skin surface. An infield topdressing is a ¼” to ½” layer at the infield skin surface of a granular material that will not stick to a players cleat, even when wet. These materials, usually made of calcined clay, vitrified clay, expanded shale, crushed aggregate or crushed brick, tend to dry more quickly on the surface then if you just had the bare soil exposed. The topdressing will dry on the surface while your infield soil underneath is still moist, but the topdressing allows you still to reenter the field. It acts much like a mulch in a landscape bed and provides many benefits in the performance of the infield.
  5. Drag the Field Before Rain Storms
    When you know a rain is coming, keep the field dragged smooth if at all possible. The water will flow more easily and rapidly off the infield if it is smooth and not pock marked with cleat marks and divots. Additionally, keep the field TIGHT! A tight field absorbs less water than one that has been deeply nail dragged, which will create pore space for water to fill and slow the drying process down considerably after the rain event.

How it rains also can have an impact in how fast your field will recuperate and come back up online for play. A long, slow light to moderate rain of a couple hours or more is very penetrating and will be deeply absorbed by your infield soil. This type of a rain usually requires longer for the field to dry from. Compare that to a heavy rain lasting 15 to 30 minutes, or even an hour. This kind of rainfall, while possibly dumping many times the amount of water than a slow rainfall did, is a violent rainfall to the soil.

 

Paul Zwaska

A former head groundskeeper for the Baltimore Orioles, Paul graduated from the University of Wisconsin in 1984 with a Bachelor’s in Soil Science with a specialty in Turf & Grounds Management. Paul took over as head groundskeeper for the Orioles’ final season at old Memorial Stadium in Baltimore and then was heavily involved throughout the design and construction phases of Oriole Park at Camden Yards which debuted on April 4, 1992.   Read more

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s